BONYPLUS
Cavifix

Class IIa Medical Device.
Device developed specifically and represents a temporary solution for obturation in case of emergency. It is fixed when it comes into contact with water or saliva. Final fixing takes place after about 15-20 minutes. It is possible to temporarily close any holes in the teeth or to replace inlays and fillings. However, it is not a material for permanent fillings. The composition has been clinically tested.

Components
Calcium sulfate; barium sulfate; glycol ether; zinc oxide; acrylic polymer; glycol ester.

How to use
Wash your hands and dry them carefully.
For the hygienic safety of the procedure described below, wear the glove included in the supply.
Clean the hole with the microbrush included in the supply.
Rinse the hole thoroughly with warm water.
Take a small amount of CavifixTM from the tube and place it on the tray included in the supply.
Roll the small amount of CavifixTM between your fingers until a small cone is formed.
Insert the cone into the hole of the tooth. See figure D. 8. Remove excess CavifixTM with the spatula tip included in the delivery.
To make sure that you have completely removed the excess CavifixTM from the tooth hole, gently close your mouth. This also ensures that CavifixTM has formed an even surface with neighboring teeth.
CavifixTM fixes after about 15 - 20 minutes of contact with the moisture in the mouth. Avoid chewing for the next 3 hours.

Warnings
Do not use in case of swelling, redness or pain of the affected area. In these cases, contact your dentist immediately. Do not use in case of open wounds. Keep the product out of the reach of children.

Format
1 tube of CavifixTM (7 g), 1 wrench, 1 tray, 1 spatula, 1 microbrush, 1 glove, instructions for use.

Cod. 28004