Doctor Bite

CE Medical Device.
Anatomical self-modeling bite, useful for preventing damage caused by Bruxism, a pathology that consists in the involuntary act of grinding and clenching the teeth.

How to use
Take the chromatic thermal indicator card with the brown dot found in the package, immerse it in a saucepan and heat the water.
Reached the right temperature (about 70 °) the sticker will change color passing from brown to gray. Immediately remove the water from the heat. A higher temperature could irreparably damage the device.
Holding the Bite by the Insertion Holder, immerse it in water for 30 seconds, covering it up to the base of the Insertion Holder.
Take the Bite out of the water and shake it lightly to remove any remaining water.
Immediately insert the Bite in the mouth, closing the teeth without clenching too much. Close your lips and suck all the air to facilitate the adhesion of the Bite on the dental arch. You can help the adaptation phase by massaging the cheeks with your fingers.
Continue for about a minute, then take the Bite out of your mouth and place it for about two minutes under a stream of cold water. At this point, try the Bite to check if a correct fit has occurred. If the fit is correct, tear the insertion holder (it is already pre-cut). At this point the Bite is ready to be used.
If the Bite is not very stable and precise, do not tear the insertion support and repeat the adaptation operations.

Cod. FIX250 / FIX260