Dr. Brux Bite Sports Self-modeling 1 Piece

Dr. Brux Bite Sportivo - Self-modeling

BruxSport® is able to rebalance the posture, eliminating dental forces, ensuring that all the muscles of the body work in a balanced and synergistic way and cooperate with each other to make the performance of the man-machine efficient.

Wearing BruxSport® during sports practice allows you to produce more useful work with the same effort and energy expenditure. In addition, BruxSport® increases the maximum ability to concentrate because it decreases the level of stress.

• High-performance: improve your sports performance
• Protective: protects the surface of the teeth

BruxSport® is the ideal solution for all sports, where in addition to benefiting from muscle rebalancing, vibration and impact absorption is also required (basketball, American football, football, skiing, mountain biking, etc.).

How to use

To start you need a kettle or a simple saucepan to heat the water, a bowl to hold the previously heated water inside, a clock, a timer or simply a mobile phone that measures the time and a mirror to simplify positioning. of the bite.

By following the instructions carefully, you will have no difficulty in positioning the bite optimally. The next step is dedicated to customization. At this point you will have to boil the water for about three minutes and return it to the container. Remove the bite from its case and take the fork for fitting. Tilting it down, you will have to insert it into the bite through the holes present. At this point you can insert the bite in your mouth, to become familiar with the next steps to be taken.

At this point, hold the fork dedicated to its adaptation and wet the bite entirely in boiling water for about 7 seconds. Only now can you extract it and, after eliminating the residual water, let it cool for a few seconds, so that it will be hot but not too hot, avoiding that it can burn you.

The next step will be to slightly widen the walls of the bite to simplify the insertion of the teeth. Be careful that the sides of the splint do not curve inwards and are bitten. At this point, you can stand in front of the mirror and, after inserting the bite into your mouth, you can close your teeth slightly, being careful not to squeeze too much. Keep your lips perfectly closed for a few minutes and suck hard to completely eliminate the air inside your mouth.

During the suction phase, compress the bite from the outside against the dental arch by making light compressions with the fingers on the mouth and from the inside push with the tongue on the frontal incisors for about a minute. It is essential that the bite is made to adhere perfectly to the teeth and not to the gums.

The third and final stage is that of stabilization. After a few minutes, take the bite out of your mouth to soak it under an abundant jet of cold water. You can now remove the fitting fork from the bite, as it is now ready to be placed in your mouth. If the customization procedure has been followed perfectly, the bite will perfectly match the upper dental arch even if you keep your mouth open.

In the event that the walls of the bite are bitten, you must again immerse the device in boiling water and then lift the compressed part again. If, on the other hand, the bite is not very stable, take care to repeat the customization operations, without skipping any steps.

To make your bite last over time, take care to clean it properly. To keep the product in perfect shape, before putting it back in its box, wash it thoroughly with toothpaste and toothbrush, to be used only for this purpose. Use cold water and don't forget, once a week, to clean it thoroughly using a disinfectant to avoid bacterial development caused by dental plaque.

Format

Pack with 1 piece.