Flaem

Breast pump

Electropneumatic

Indications:

Suction Pump aspirator, transportable for home care, suitable for outpatient use, lubrication-free, handy, simple to use, reliable, resistant and silent.

Dosage and method of use:

connect, using the short tube, the antibacterial filter and / or the air intake of the appliance to the socket "A" (OUT) of the motor protection vessel. Using the long tube, connect the socket "B" (IN) of the motor protection jar with the breast pump cup screwed onto the bottle. Insert the plug into the socket (corresponding to the voltage of the appliance). Start the appliance by operating the switch, bearing in mind that the appliance is intended for temporary use, maximum 20 min., On a horizontal plane for the correct functioning of the protection device against liquid ingress into the suction pump and free from walls to allow adequate cooling of the engine. By means of the vacuum regulator it is possible to set the desired depression value (bar). By turning the knob towards (+) you get a higher depression value and turning towards (-) the lower depression value; these values can be read on the "vacuum gauge" instrument. Rest the breast pump cup. Place your finger in the hole C of the breast pump and start the operation. With the discontinuous support of the finger, it is possible to obtain an impulse aspiration. After the application, switch off the appliance. Before restarting the appliance, make sure that it has cooled down to room temperature. Disconnect the plug and empty and clean the bottle and the connection tubes.

Characteristics:

it contains a motor protection jar with protection device, a short connection tube, an antibacterial filter (where provided), a long connection tube, a 250 ml bottle, a breast pump cup, a bottle cap suitable for storing milk.
Built in compliance with the essential requirements of the European Directive 93 / 42CEE for medical devices and compliant with the safety standard for "Electrically operated aspirators" UNI EN ISO 10079-1 of September 2000 (based on IEC 60601-1).

Voltage: 230V- 50Hz 190VA.
Fuse: T 2A - 250V.
Adjustable vacuum level: from 0 to -0.7 bar approx (high vacuum).
Air flow to the compressor: 11 l / min approx (low flow).
Dimensions: 22x17x17 cm.
Weight: 2,300 Kg.
Noise (at 1 m): 60 dB (A).
Temporary use: max 20 minutes.
Operating conditions: Temperature: min. 10 ° C; max. 40 ° C.
Air humidity: min. 10%; max. 95%.
Storage conditions: Temperature: min. -25 ° C; max. 70 ° C.
Air humidity: min. 10%; max. 95%.
Operating / storage atmospheric pressure: min. 690 hPa; max. 1060 hPa.
Compliant with directive 93/42 EEC CE 005.

Warnings:

the accessories must be carefully inspected, making sure that there is no dust, encrustations, lumps or liquid substances both inside the connection pipes and in the motor protection valve, the baby bottle and the respective closing caps. They also need to be cleaned or disinfected.
In the presence of pathologies with risks of infection and microbial contamination, we recommend a personal use of the accessories, baby bottle, motor protection jar and connection tubes (consult your doctor).

Cod. P400P00