Mesauda Milan

Base / Top Gel Polish

Semi-permanent Gel Polish

It is a revolutionary semi-permanent UV and LED gel polish that coats and colors the natural nail
and fully cures in less than 2 minutes. This patented product can be cured both with normal UV lamp (2 minutes) and with LED lamp (30 seconds - 1 minute).

How to use

1. Dull the surface of the nails with the abrasive brick (buffer).
2. Carefully dust off all the dust that has formed with a brush.
3. Apply a layer of "nail prep" to gently degrease and dehydrate the natural nail and let it air dry for 30 seconds.
4. Apply a layer of “ultrabond” (non-acid primer), allow to air dry for 30 seconds and do not remove the sticky layer it produces after drying.
5. Apply a layer of "base & top gel" gelpolish taking care not to touch the cuticles and let it cure in a 36 watt UV lamp for 2 minutes and do not remove the sticky layer it produces after drying.
   NB: for easier removal of the product it is recommended to use the specific gelpolish "soak off base" base, using the "base & top gel" only as a finishing top coat.
6. Apply a thin layer of colored gel polish taking care not to touch the cuticles and let it cure in a 36 watt UV lamp for 2 minutes and leave the sticky layer it produces after drying.
7. Proceed with a second layer of colored gel polish (always thin) taking care not to touch the cuticles and let it polymerize in a 36 watt UV lamp for 2 minutes and leave the sticky layer it produces after drying.
8. Apply a last layer of "base & top gel" polish taking care not to touch the cuticles and let it cure in a 36 watt UV lamp for 4 minutes.
9. Then degrease with the “cleanser” to eliminate the sticky layer and to finish the job

Removal

1. File the shiny layer of the enamel with a 100/180 file, taking care not to damage the natural nail.
2. Soak your nails in warm (not hot!) Water for about 5 minutes.
3. Apply a cotton ball soaked in soak-off remover over each nail and carefully wrap it with aluminum foil. leave on for about 5 minutes.
4. Remove the aluminum foil and cotton balls. The softened enamel can be easily removed with the help of an orange stick.
5. Remove any residues with the abrasive brick (buffer).

Format

5ml bottle.