Neapolitan Mechanics Wall Dispenser

Partenopea Mechanics Wall Dispenser - Automatic

Automatic soap foam dispenser.

Technical features

• Model: F1309
• Dimension: 110x100x165 mm
• Capacity: 600 ml
• Drop volume: 1 or 2 ml (soap); 0.7 or 1.4 ml (foam)
• Weight: 480 g
• Material: ABS, PC
• Battery: AA or DC6V
• Power source voltage: DC6V
• Static current: 50 mcA
• Operation Current: 300mA
• Power: 1.8W
• Effective distance: 8-12cm.

How to use

• Use the mounting plate as a template to mark the location.
• Drill two 5mm holes and insert the plugs into the holes.
• Secure the mounting plate to the wall with the supplied screws.
• Slide the distributor into the mounting plate.
• Insert the 4-piece batteries into the battery compartment respecting the polarity indicated on the compartment. Alkaline battery is recommended. If you use the plug of the DC6V power supply in the DC interface of the distributor.
• Open the lid and fill the soap or foam into the container.
• Put your hand under the sensor 8-12cm and let the dispenser start working continuously until the liquid soap comes out of the nozzle. When using the dispenser for the first time, there will be some air in the pump, you need to work on the dispenser several times until you drop the liquid soap or foam.

Warnings

Do not install the dispenser above the mirror surface or above the running water.
Do not install the dispenser less than 50 cm (2 inches) under the table.
The soap dispenser is suitable for the soap liquid, the foam dispenser is suitable for the foam liquid, it cannot be mixed, otherwise it will cause the dispenser to malfunction.
The sensor is located at the base of the dispenser. The range of the effect is between 8 and 12 cm below the sensor.
The product is designed for indoor use only. Direct sunlight or exposed locations can destroy the infrared sensor of the product. Low voltage indicator when the LED light flashes continuously while the dispenser is in standby mode, the battery needs to be replaced.
Do not use alcohol or other chemical liquids.
This product does not have the waterproof function, please place the product away from moisture

If the dispenser doesn't work

Check if the battery is consumed or not at the right polarity;
Power switch not open.

If the vending machine doesn't stop

It is necessary to use the dispenser several times at the first use;
The liquid freezes in winter, it is necessary to fill it with a little hot water (about 80 ° C), after a few minutes of operation;
There may be no liquid present.
If there is dust in the container, clean the container, then refill with the liquid.
Do not use water to wash the dispenser, clean the surface with a damp cloth; use a dry towel to clean the battery compartment. If not in use, please fill with a little water, then use the dispenser several times to clean the outlet tube and take out the battery.

Format

Pack of 1 automatic dispenser.